www.quadsoftware.com
FAQ  FAQ   Search  Search   Memberlist  Memberlist   Usergroups  Usergroups
Register  ::  Log in Log in to check your private messages


Post new topic  Reply to topic
 Selection Layers: Disconnected/out of scale « View previous topic :: View next topic » 
Author Message
makit3d
PostPosted: Sun Apr 08, 2007 10:03 pm    Post subject: Selection Layers: Disconnected/out of scale Reply with quote



Joined: 10 Feb 2007
Posts: 123

I have sent a bug report to the support email already. I went ahead and started a clean file and generated a map using the QImport feature. Each map was placed by coordinates rather than grid or zone snapping.

After I was satisfied I had all my zones created and placed I assigned a Heightfield and Selection layers to the zones. After doing so the attached images shows the result. The selection layer is much smaller than the level and disconnected from it. Also, it appears the selection layer has taken all the zones associations and stacked them one atop the other.

Back to top
View user's profile Send private message
ALicu
PostPosted: Thu Apr 26, 2007 8:19 am    Post subject: Reply with quote



Joined: 12 Feb 2007
Posts: 1326

I just wanted to say that this bug was fixed by a previous patch just to be sure nobody post it again.

Thanks Richard for you report.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Based on a template by Dustin Baccetti
Powered by phpBB © 2001, 2005 phpBB Group